GUITAR AMPLIFIER
HARDWARE
MACHINE SCREWS
KEP NUTS
STANDOFFS / SPACERS
SOLDER / GROUND LUGS FENDER WASHER CHASSIS BOLTS
MACHINE SCREWS
High quality stainless. Philips pan head.
4-40, 6-32 & 8-32 Thread sizes available.
4-40 screws are good for mounting 9 pin sockets and other
small parts.
6-32 screws are good for octal sockets, some output transformers and for mounting
turret boards.
8-32 screws are good for mounting power transformers, output transformers and
other heavier parts.
 |
Only $0.18 ea
STAINLESS
STEEL KEP NUTS
ALUMINUM HEX STANDOFFS WITH HARDWARE 1/4" ALUMINUM
STANDOFF
These have the built in rotating lock washers. No washer needed.
#8 Kep nuts are standard for mounting speakers.
Only $0.18 each
W/ STAINLESS SCREW AND LOCKING NUT.
These are good for low profile boards like some Fenders.
1/2" ALUMINUM STANDOFF
W/ BLACK SCREW AND ZINC LOCKING NUT.
3/4" ALUMINUM STANDOFF
W/ STAINLESS SCREW AND LOCKING NUT.
This setup will mount your circuit board up higher for easier access to under
board wires.
 |
only $1.00
 |
These are used for grounding points in your amp. Bolt them down to your
chassis and solder your ground wires right to them.
If you are using a 4/40 screw, use a size 4 ground lug, a 6/32 screw a #6 lug
etc...
#6 lugs come in 2 different styles. Single hole and double hole.
Only... $0.25 each
SOLDER LUGS
CRIMP STYLE
|
|
These can be crimped and soldered for extra
stability.
Only... $0.25 each
FENDER WASHER... $0.25 each
#8 hole. 3/4" diameter.
Perfect for power or output transformer support.
|
|
CHASSIS BOLTS... $0.20 per
These fit all of our blank chassis
High quality zinc. Phillips head. 1-1/4" long.
NO PHOTO AVAILABLE